Lumiscope 1095 User Manual download pdf (Page 6)

• Wrap the cuf

f as close to the skin as possible.

(Do NOT roll shirts or jackets up over the arm when

taking a measurement. This will constrict the upper

arm and prevent accurate measurement.)

• When using the monitor attached to the cuff, the

monitor and artery mark should be on the inside of

your arm (fig. H).

• When using the monitor as a tabletop unit, the cuff

tube should be placed on the inside of your arm (fig. I).

• Make sure that the cuff is fastened firmly. Note that

wrapping the cuff unevenly will prevent proper meas-

urement.

Rest left elbow on a table so that the cuff is at heart level. Relax the lower arm across

the table and remain still. Perform measurements in either a seated or reclining posture

with the left palm turned upwar

Fits Arm Circumference: 8.66 to 12.6 inches

NOTE: If the Index line falls within the OK range (indicated along the upper edge of the

cuff) this cuff is suitable for your use. If the Index line falls out of the OK range, con-

tact the Lumiscope Service Dept. for an Oversize cuff. (model # 109-235)

Attaching of Arm Cuff and

Posture During Measurement

Unfasten and open the cuff as shown in the fig-

ure, leaving the “Index” end of the cuff through

the “D” ring (fig. F).

Wrap the arm cuff around the upper left arm

firmly so that bottom edge of the cuff is posi-

tioned about one inch above the elbow joint.

Position the cuff so that the artery mark is in

the middle of the arm, in line with the middle

finger (fig. E).

2~3 cm

0.8~1.2 inch

Artery

region

Artery Mark

Fig. F

Fig. G

Fig. H

Fig. I

1 2 3 4 5 6 7 8 9 10 11

No comments

Lumiscope 1095 User Manual Page 6